Parkside PAS 500 D3 Manuale Utente Scaricare il pdf (Pagina 45)

45

GB MT

Cleaning/Maintenance

Pull out the mains plug.

Danger of electric shock.

Never hose the appliance down

with water. Never use aggressive

cleaning agents or solvents. This

could damage the appliance.

If the single-use thermal fuse has

permanently disconnected the pow-

er circuit, the device must be sent to

a service centre for repair.

General Cleaning Work

Clean the equipment after each use:

• Carry out cleaning outside in order to

avoid mess.

• Remove the container lid (

5) and

the pre-lter (

15) and empty the

metal container (

10). Clean the

metal container with water and allow it

to dry.

• Tap the pre-lter (

15) and clean it

with a brush or hand-brush.

• After removing the suction hose (

11), clean the dust and soot particles

from the connections. This ensures that

the suction hose can be inserted again

easily.

• Clean the metal lter cage and the

pleated lter (see below).

Cleaning the Metal lter

cage and Pleated Filter

Replace the pleated lter if it is

worn, damaged or heavily soiled

(see “replacement parts“).

1. Take off the container cover (5).

2. Turn the metal lter cage (14)

anticlockwise and take it off.

Tap out the metal lter cage.

3. Tap out the pleated lter (13)

and clean it with a paintbrush

or hand brush.

Don‘t wash the pleated

lter in water.

4. Place the pleated lter (13) on

the rotated container lid (5) (see

small image

).

Here, the

0mm

16a16b

rubber ring

must be on

the contain-

er lid and

press the

safety stop switch (16a) down-

wards. Make sure that the pres-

sure mark on the rubber ring is

re-positioned on the switch of

the safety stop.

5. Pull the metal lter cage (14)

over the pleated lter (13) and

turn it clockwise until it stops.

The safety stop (16b) must be

pressed down.

If there is play in the metal lter

cage (14), use a nger to press

down the metal lugs (17).

Cleaning the Air Filter

1. Take off the container cover (5),

metal lter cage (

14) and

pleated lter (

13).

2. Take the air lter (18) out of the

lter housing (19).

3. Clean the lter with soap and

water and allow it to dry in the

air.

4. Place the air lter (18) back in

the lter housing (19).

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 65 66

Commenti su questo manuale

Nessun commento